LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 474 (Automatic Transmission) >> Diagnosis And Testing >> Diagnostic Flow Chart

Diagnostic Flow Chart

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC FLOW

Diagnostic Flow Chart
  • Know and understand the customer's concerns
  • Check the fluid level and condition
  • Verify the concern by operating the vehicle
  • Check for non-factory installed items and verify correct installation
  • Check the shift linkage adjustments
  • Check TSBs for vehicle concerns
  • Carry out quick test both KOER and KOEO
  • Record all codes
1) Did you record any Diagnostic Trouble Codes?
Yes
No
2) Are any continuous test memory codes present? Yes
  • CLEAR codes and carry out drive cycle test.
No
  • GO to Step 4.
3) Did the continuous test memory codes reappear? Yes
No
  • GO to Step 4.
4) Is the concern repaired? Yes
  • CARRY OUT the final quick test to verify that no Diagnostic Trouble Codes are present. CLEAR memory codes.
No
5) Are there any electrical concerns? Yes
  • INSTALL the diagnostic tool and CARRY OUT output state control test, then GO to Step 6.
No
6) Was the transmission concern corrected when the scan tool was installed? Yes
  • REFER to the INTRODUCTION - CNG, FLEX-FUEL & GASOLINE article, intermittent fault diagnosis and use the diagnostic tool or WDS to diagnose cause of concern in the processor, vehicle harness or external inputs (sensors or switches).
No
7) Is the concern repaired? Yes
  • CARRY OUT the final quick test to verify that no diagnostic trouble codes are present. CLEAR memory codes.
No
  • Repeat procedure as necessary.