LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 349 (Automatic Transaxle/Transmission) >> In-Vehicle Repair >> Output Shaft Speed (OSS) Sensor >> Removal

Output Shaft Speed (OSS) Sensor: Removal

WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable.
  2. Remove the air cleaner assembly.
  3. Disconnect the output shaft speed sensor electrical connector.
    Fig 1: Disconnecting Output Shaft Speed Sensor Electrical Connector
    G03412254Courtesy of FORD MOTOR CO.
  4. Raise and support the vehicle. .
  5. Remove the LH wheel and tire assembly.
  6. Remove the LH inner fender splash shield bolt.
    Fig 2: Removing LH Inner Fender Splash Shield Bolt
    G03412255Courtesy of FORD MOTOR CO.
  7. Remove the LH inner fender splash shield.
    1. Remove the bolts.
    2. Remove the splash shield.
      Fig 3: Removing Bolts
      G03412256Courtesy of FORD MOTOR CO.
  8. Remove the output shaft speed sensor.
    1. Remove the bolt.
    2. Remove the sensor.
      Fig 4: Removing Output Shaft Speed Sensor
      G03412257Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals