LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Steering Column Switches) >> Component Tests >> MULTIFUNCTION Switch

MULTIFUNCTION Switch

WARNING: This page is about a different car, the 2002 Lincoln Navigator, 2002 Ford Expedition, 2001 Lincoln Navigator, and 2001 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

Remove and disconnect multifunction switch. See MULTIFUNCTION SWITCH  under REMOVAL & INSTALLATION. Measure resistance between specified terminals at multifunction switch. See MULTIFUNCTION SWITCH TESTING  table. See Fig 1. If resistance is not as specified, replace multifunction switch.

MULTIFUNCTION SWITCH TESTING

Switch Position Between Terminals No. (1) Ohms
Wiper Switch
Off 589 & 993 47,600
Intermittent 589 & 993 11,330
Low 589 & 993 4080
High 589 & 993 0-4
Front Intermittent Wipers
Intermittent & Off 589 & 993 (2)
Low & High 589 & 993 3300
Washer Switch
Off 590 & 993 103,300
On 590 & 993 0-4
Rear Wiper Switch
Off 380 & 993 2900
Intermittent 1 380 & 993 11,000
Intermittent 2 380 & 993 330
Rear Washer Switch 380 & 993 0-4
Hazard Switch On 2, 4, 5, 8 & 10 0-4
Left Turn Signal On 1, 10 & 8 0-4
Right Turn Signal On 1, 2 & 5 0-4
High Beam 15 & 12 0-4
Low Beam 15 & 507 0-4
Flash-To-Pass On 12 & 196 0-4
(1) Specification can vary by as much as 10 percent.
(2) Rotate control from maximum delay to minimum delay. Resistance should gradually decrease from approximately 103,000 to 3300 ohms.
Fig 1: Identifying Multifunction Switch Terminals
G99H02682Courtesy of FORD MOTOR CO.