LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1480 (Manual Transmission External Controls) >> Removal And Installation >> Gearshift Lever >> Installation

Gearshift Lever: Installation

WARNING: This page is about a different car, the 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the gearshift lever.
  2. Connect the select cable.
    Fig 1: Connecting Select Cable
    G04621102Courtesy of FORD MOTOR CO.
  3. Connect the gearshift cable.
    Fig 2: Connecting Gearshift Cable
    G04621103Courtesy of FORD MOTOR CO.
  4. Install the 2 gearshift cable clips.
    CAUTION: Make sure the clips are set completely within the cable adapter groove and fully seated.
    Fig 3: Locating Gearshift Cable Clips
    G04621104Courtesy of FORD MOTOR CO.
  5. Install the 4 gearshift lever bolts.
    • Tighten to 25 Nm (18 lb-ft).
  6. Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION .
  7. Install the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
scientia non olet · About LEMON Manuals