Gearshift Cables: Installation

WARNING: This page is about a different car, the 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Insert the gearshift cables through the dash panel.
CAUTION: When inserting the gearshift cables through the dash panel, make sure the arrow on the grommet is pointing down.

Fig 1: Inserting Gearshift Cables Through Dash Panel
Courtesy of FORD MOTOR CO.
Connect the select cable.

Fig 2: Connecting Select Cable
Courtesy of FORD MOTOR CO.
Connect the gearshift cable.

Fig 3: Connecting Gearshift Cable
Courtesy of FORD MOTOR CO.
Install the 2 gearshift cable grommet nuts.
- Tighten to 10 Nm (89 lb-in).
Install the 2 gearshift cable clips.
CAUTION: Make sure the clips are set completely within the cable adapter groove and fully seated.

Fig 4: Locating Gearshift Cable Clips
Courtesy of FORD MOTOR CO.
Connect the gearshift cables to the transaxle gearshift control assembly.
Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION .
Install the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
Install the RCM. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .