LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1248 (Driveshaft) >> Disassembly And Assembly >> Driveshaft Center Bearing >> Assembly

Driveshaft Center Bearing: Assembly

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the center bearing and bracket assembly and the retaining ring on the yoke.
    Fig 1: Positioning Center Bearing And Bracket Assembly And Retaining Ring On Yoke
    G03995181Courtesy of FORD MOTOR CO.
  2. Using the special tool, drive the retaining ring and bearing assembly until fully seated on the yoke.
    Fig 2: Driving Retaining Ring And Bearing Assembly
    G03995182Courtesy of FORD MOTOR CO.
  3. Assemble the front and rear shaft assemblies.
  4. Install the driveshaft. For additional information, refer to DRIVESHAFT  in this article .
scientia non olet · About LEMON Manuals