LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Controls - Basic Diagnostic Procedures - Except Diesel) >> Idle Speed & Ignition Timing >> Ignition Timing >> Villager

Ignition Timing: Villager

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2000 Mercury Villager, 2000 Mercury Mountaineer, 2000 Lincoln Navigator, 2000 Ford Windstar, and 2000 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure engine is at operating temperature, all accessories are off, and transmission is in Park or Neutral. Set parking brake. Ensure idle speed is correct.
  2. Connect timing light to No. 1 spark plug wire. Disconnect Idle Air Control (IAC) wiring harness connector. Start engine. Check base ignition timing. See IGNITION TIMING  table.
  3. If timing is not to specification, loosen distributor hold-down bolt. Adjust timing as necessary. Turn engine off. Reconnect IAC harness connector. Start engine. Ensure advance mechanism functions when engine speed is increased.
IGNITION TIMING

Application Degrees BTDC
Except Villager 8-10
Villager (1) 13-17
(1) With IAC solenoid connector unplugged.
scientia non olet · About LEMON Manuals