LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1999 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Window System >> Removal & Installation >> Power Window Motor >> Removal & Installation

Removal & Installation

  1. Remove door trim panel and trim shield. Remove side view mirror. Reinstall window control switch and lower window to align window regulator-to-window glass retaining bolts with access holes in door.
  2. Disconnect negative battery cable. Disconnect window control switch harness connector. Remove 2 bolts retaining window regulator to window glass. While holding window glass, carefully pry regulator from glass. Pull belt line outside weatherstrip from door.
  3. Raise rear of window glass and carefully remove from door. Loosen 3 regulator-to-door retaining bolts. Remove 3 window motor bolts. Slide window regulator bolts from slots in door and disconnect power window motor harness connector. Remove window regulator.
  4. Remove screws retaining window motor to window regulator. To install, reverse removal procedure. Tighten window regulator-to-window glass retaining bolts to 71 INCH lbs. (8 N.m).
scientia non olet · About LEMON Manuals