PCM Reset
After a PCM reset procedure has been performed, the following conditions will be met:
- All DTCs will be cleared from PCM memory.
- All freeze frame data will be cleared from PCM memory.
- All oxygen sensor test data will be cleared from PCM memory.
- OBD-II system monitor status will reset.
- DTC P1000 will be set in PCM memory.
To perform PCM reset using scan tool, follow scan tool manufacturer's operating instructions. If after clearing DTCs a problem has not been corrected or fault is still present, hard code will immediately be reset in PCM memory.
CAUTION:
When battery is disconnected, vehicle computer may lose memory data. Driveability problems may exist until computer systems have completed a relearn cycle. See COMPUTER RELEARN PROCEDURES article in the GENERAL INFORMATION section before disconnecting battery.