Memory Set Switch

WARNING: This page is about a different car, the 1998 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

Remove memory set switch and disconnect harness connector. Measure resistance between appropriate memory switch terminals with switch in each position. See MEMORY SET SWITCH RESISTANCE table. See Fig 1 . If resistance is not as specified, replace memory switch.

MEMORY SET SWITCH RESISTANCE

Switch Position

Terminals No.

Ohms

Neutral ⁽¹⁾

1 & 8

Greater Than 10,000

SET

1 & 6

Less Than 5

MEM 1

6 & 3

Less Than 5

MEM 2

6 & 4

Less Than 5

⁽¹⁾	Between terminals No. 8 and 9, resistance should be infinite. When ohmmeter leads are reversed, resistance should be low.

Fig 1: Identifying Memory Switch Terminals

Courtesy of FORD MOTOR CO.