Door Lock Actuator Test
WARNING: This page is about a different car, the 1997 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
When performing the following test, DO NOT not apply power to actuator for longer than 5 seconds.
- Apply 12 volts to actuator terminals. Actuator should operate. Actuator rod should complete its travel in less than one second. Transpose leads to actuator. Actuator should operate in reverse direction at same speed.
- Measure actuator current. Transpose jumper leads to measure reverse current. Replace actuator if current exceeds 6 amps, or if response is not as specified.