Performing Drive Cycle
- Turn ignition on, but do not crank engine until WAIT TO START light turns off, or 10 seconds has passed (whichever is greater).
- Start engine. Allow engine to idle with transmission in Park for 40 seconds.
- The following conditions must be followed to run certain OBD-II monitors that require engine to be under a load. Depress OVERDRIVE switch (overdrive mode off) to perform test in 3rd gear. Turn on accessories (headlights, A/C compressor, blower fan, etc.). DO NOT use hazards or PTO. Select an uphill or level road. DO NOT select a downhill road. Driving downhill will unload engine and defeat test.
- Accelerate steadily to 3rd gear and keep engine speed at 1500 RPM for 3 seconds. Accelerate steadily from 35 MPH to 65 MPH in about 15 seconds. Repeat this procedure 3 times while maintaining conditions set in step 3). Before proceeding, turn all accessories off and depress OVERDRIVE switch (overdrive mode on). On A/T models, go to next step.
- On A/T models, drive vehicle in 4th gear continuously for one minute. Accelerate steadily from a full stop to 4th gear and then return to a full stop. Repeat this procedure 10 times, then go to next step.
- Before continuing, use scan tool and select EOT PID from PID/DATA monitor menu. Ensure EOT PID value is more than 140°F (60°C). Allow engine to idle for 20 seconds in Park. Turn ignition off. State engine. Allow engine to idle for 40 seconds in Park. Repeat QUICK TEST . Drive cycle is complete.
- If P1000 is present after performing drive cycle, repeat step 4) maintaining a minimum MFDES PID value of 37 milligrams/stroke with engine speed at more than 1500 RPM for 11 seconds. Also, repeat step 6). MFDES PID value must remain less than 12 milligrams/stroke for 11 seconds.