Intermittent Simulation
WARNING: This page is about a different car, the 1997 Ford Aspire. However, it is still accessible from the selected car via links, so may be relevant.
To reproduce the conditions creating an intermittent fault, use the following methods:
- Lightly tap on component.
- Heat component using a heat gun.
- Wiggle or bend wiring harness.
- Spray component with water.
- Remove/apply vacuum source.
Monitor circuit/component voltage or resistance while simulating intermittent. Use test results to identify a faulty component or circuit. If no faults are found, go to CIRCUIT TEST Z in the TESTS W/CODES article.