LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1997 >> Explorer 2D Utility, 4.0 X, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls - Remove/Install/Overhaul - 5.0L) >> Ignition System >> Powertrain Control Module >> Removal & Installation

Removal & Installation

WARNING: This page is about a different variant/trim than selected.

Disconnect negative battery cable. Remove any component necessary to gain access to PCM. For PCM location, see PCM LOCATION table. Loosen PCM connector retaining bolt (if equipped). Unplug harness connector from PCM. Remove 2 PCM mounting bolts. Remove PCM cover and PCM. To install, reverse removal procedure.

PCM LOCATION

Model Location
Explorer In Cowl Area (Passenger Side)
scientia non olet · About LEMON Manuals