LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Windstar GL, 3.0 U >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Engine Controls - Remove/Install/Overhaul - 3.8L) >> Computerized Engine Controls >> Powertrain Control Module >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 1997 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect battery ground cable. Powertrain Control Module (PCM) is located in cowl on passenger side. Remove cowl top vent panel. Loosen engine control sensor wiring to PCM connector retainer bolt. Remove engine control sensor wiring connector from PCM. Remove two PCM cover nuts. Remove PCM cover. Pull powertrain control module out of bracket. To install, reverse removal procedure.

scientia non olet · About LEMON Manuals