System Does Not Disengage When Brakes Are Applied
NOTE:
On Probe, servo assembly is grounded through mounting bolts. When instructed to connect tester to pin No. 10, connect tester to chassis ground. Ensure mounting bolts are clean and tight.
- Check Deactivator Switch Circuit - Disconnect servo connector. Without brakes applied, measure voltage between servo connector pins No. 9 and 10. If battery voltage exists, go to next step. If battery voltage does not exist, repair deactivator circuit. See SYSTEM INOPERATIVE test.
- Check Deactivator Switch Operation - Disconnect servo connector. Apply brakes. Measure voltage between servo connector pins No. 9 and 10. If battery voltage exists, replace deactivator switch. If battery voltage does not exist, go to next step.
- Check Stoplight Switch - Unplug servo connector. With brakes applied, measure voltage between servo connector pins No. 4 and 10. See Figure . If battery voltage exists, go to next step. If battery voltage does not exist, replace brake switch, fuse, or repair open circuit.
- Check For Binding Servo Cable - Remove servo cable from servo. Check for breaks or binding by pulling on cable ball slug. If throttle does not operate freely, check throttle plate operation. Replace cable if necessary. If cable is okay, replace servo assembly.