LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Contour SE, Standard >> Repair and Diagnosis >> Electrical >> Starter >> Removal & Installation >> 2.0L >> Installation

Removal & Installation: 2.0L: Installation

NOTE: When installing lower starter motor retaining bolts, be sure to install ground cable.
  1. Position starter motor (11002) to transaxle and loosely install lower retaining bolt.
  2. Install axle shaft bearing bracket. Tighten to 21 N-m (15 lb-ft).
  3. Connect knock sensor (12A699).
  4. Install integral connector retaining nuts. Tighten B-terminal retaining nut to 11 N-m (97 lb-in). Tighten S-terminal retaining nut to 5 N-m (44 lb-in).
  5. Lower vehicle to floor.
  6. Install starter motor retaining bolts and ground wire. Tighten to 20 N-m (15 lb-ft).
  7. Connect the IAT and MAF.
  8. Connect battery ground cable.
scientia non olet · About LEMON Manuals