Valve Body (Main Control) Assembly: Reassembly

1. Install all valves into their respective bores using illustration as guide. Ensure notch in plugs face bottom of bore.
2. Install valve body check balls. See Fig 1 . Install guide pin bolts into holes. These 2 holes align valve body gasket and valve body assembly with case. Using a NEW separator plate gasket, slide plate and gasket over alignment pins. Position 3 reinforcement plates and loosely install retaining bolts. Tighten retaining bolts to specification. See TORQUE SPECIFICATIONS  .

Fig 1: Locating Check Balls In Valve Body

Courtesy of FORD MOTOR CO.

Fig 2: Exploded View Of Valve Body Components

Courtesy of FORD MOTOR CO.