Clearing Trouble Codes
After all stored trouble DTCs have been retrieved and serviced, remove tester or jumper wire from ABS test connector. Cycle ignition switch on and off. Drive vehicle at about 15 MPH. Stored DTCs should be cleared. If DTCs are not cleared, check for more stored DTCs. All DTCs must be retrieved before memory can be cleared.
DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC (Definition) | Pinpoint Test (Step) | ||
|---|---|---|---|
| 12 (System Okay) | D (1) | ||
| 19 (ABS Control Module) | D (1) | ||
| 22 (RF Valve) | A (1) | ||
| 24 (LF Valve) | A (2) | ||
| 26 (Rear ABS Valve) | A (3) | ||
| 31 (RF Wheel Sensor) | B (1) | ||
| 32 (RR Wheel Sensor) | B (4) | ||
| 33 (LF Wheel Sensor) | B (7) | ||
| 34 (LR Wheel Sensor) | B (10) | ||
| 41 (RF Wheel Sensor) | C (1) | ||
| 42 (RR Wheel Sensor) | C (3) | ||
| 43 (LF Wheel Sensor) | C (5) | ||
| 44 (LR Wheel Sensor) | C (7) | ||
| 61 (Pump Motor/Motor Relay) | D (1) | ||
| 63 (Voltage Interruption) | D (1) | ||
| 69 (Low Voltage) | D (1) | ||
| 78 (Sensor Frequency) | (1) | ||
| ANTI-LOCK Warning Light Always On (No DTCs) | F | ||
|
|||