Gearshift Cable

With engine off and parking brake applied, set shift lever to "OD" position. Hang a 3-lb. (1.4 kg) weight on lever.
Raise and support vehicle. Release lock tab on top of shift cable at transmission bracket by pushing tangs downward. Disconnect shift cable from manual lever on transmission.
On Aerostar models, move manual lever all the way forward, then rearward 3 detent positions. On Explorer and Ranger models, move manual lever all the way rearward, then forward 3 detent positions.
On all models, reconnect shift cable at manual lever on transmission. Push lock tab downward. Ensure lock tab fully engages and gearshift cable is locked in place.
Ensure shift cable is properly secured to floor panels. Lower vehicle. If shift indicator does not align with "OD" position on instrument panel, rotate thumb screw near shift indicator until properly aligned. Remove weight from shift lever.

NOTE: If necessary, remove steering column covers to gain access to thumb screw for shift indicator adjustment. Ensure transmission operates in all gear ranges with correct transmission detent position.