LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1994 >> Probe Base, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Supercharger >> Removal & Installation (3.8L SC)

Removal & Installation (3.8L SC)

  1. Clean areas surrounding supercharger. Disconnect negative battery cable. Remove throttle body air inlet tubes. Remove cowl vent screens. Partially drain cooling system.
  2. Remove right side spark plug wires at ignition coil. Remove all vacuum and electrical connectors from upper intake manifold and throttle body. Remove EGR tubes from EGR valve. Disconnect EGR transducer.
  3. Remove throttle linkage and bracket. Disconnect speed control (if equipped). Remove supercharger drive belt. Remove charge air cooler inlet and outlet tubes. See CHARGE AIR COOLER INLET TUBE and CHARGE AIR COOLER OUTLET TUBE.
  4. Remove 3 intake elbow bolts. Remove 3 supercharger retaining bolts. Lift supercharger and intake assembly from vehicle as a unit. See Figure. To install, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS TABLE (V6).
scientia non olet · About LEMON Manuals