LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1994 >> Probe Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Crankshaft Position Sensor >> Removal (3.0L SHO & 3.2L SHO)

Removal (3.0L SHO & 3.2L SHO)

  1. Disconnect negative battery cable. Loosen A/C compressor and power steering pump tensioner pulleys. Remove belts from crankshaft pulley. Remove ignition control module and intake manifold crossover tube. Remove upper timing belt cover. Disconnect sensor wiring harness at connector, and route wiring harness through belt cover.
  2. Raise vehicle. Remove right front wheel. Using a universal puller, remove crankshaft pulley and vibration damper. Remove lower timing belt cover. Rotate crankshaft by hand to position metal vane of shutter outside of sensor air gap. Remove crankshaft sensor mounting screws and sensor.
scientia non olet · About LEMON Manuals