LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1994 >> Probe Base, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> Upper Intake Manifold >> Removal (3.0L SHO & 3.2L SHO)

Removal (3.0L SHO & 3.2L SHO)

  1. Partially drain cooling system and disconnect negative battery cable. Remove intake air ducting from throttle body and mass airflow sensor. Disconnect throttle cables. Disconnect electrical connectors from throttle position sensor, idle air control valve, vacuum switching valve and ignition control module.
  2. Disconnect coolant by-pass hoses. Disconnect and mark all vacuum lines from upper intake manifold and throttle body. Disconnect EGR pipe from EGR valve.
  3. Remove 8 bolts from upper intake manifold support brackets, and remove brackets. Remove coolant hose bracket bolt. Remove remaining 12 upper intake manifold bolts. Remove upper intake manifold and throttle body as an assembly.
NOTE: Metal intake manifold gaskets can be reused if undamaged.
scientia non olet · About LEMON Manuals