Non-Generic OBD II Parameter Identification (PID)

Turn ignition switch to OFF position. Ensure test equipment is properly attached. Program scan tester using the following steps:

• Select vehicle and engine selection menu. See Figure .
• Select year, engine, model and any additional information requested by scan tester.
• Select GENERIC OBD II OPTIONS. Press CONT button if monitors are not complete.
• Select DIAGNOSTIC DATA LINK.
• Select PCM - POWERTRAIN CTRL MODULE.
• Select DIAGNOSTIC TEST MODES.
• Select PID DATA MONITOR AND RECORD.
• Turn ignition on or start engine and allow to idle.
• Follow operating instructions from scan tester menu.
• Select PIDs and press START.