Test D - Verify Triggered Alarm Disarming
- Arm system with driver's side window down. Reach through window and open door using inside handle. Insert key and turn to unlock position. Repeat for passenger door and liftgate. If alarm triggers, then turns off, system is okay, go to step 3). If alarm does not turn off, go to next step.
- Using voltmeter, check voltage at control module pin No. 6 with door key in unlock position. If voltage is more than one volt, repair door disarm switch or check for open in Dark Green/Purple wire and retest system. If voltage is less than one volt, replace control module and retest system.
- Arm system with a front window down. Reach through window and open door using inside handle. Activate remote entry UNLOCK button. If alarm triggers, then turns off, system is okay, go to step 5). If alarm does not trigger, go to next step.
- Using a voltmeter, check that a momentary B+ signal is present at pin No. 8, when remote transmitter UNLOCK button is activated. If B+ signal is present, replace control module and retest system. If less than one volt is present, repair Red/Orange wire and retest system.
- Arm system with front window down. Open door using inside door handle. Wait 4 minutes. If alarm triggers, then shuts off after 3-4 minutes and vehicle will not start, system is okay. Test is complete, disarm system. If alarm does not shut off, or vehicle starts, replace control module and retest system.