LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1994 >> Crown Victoria S >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Engine Controls - Adjustments - Gasoline) >> Ignition Timing >> Initial Timing

Initial Timing

WARNING: This page is about a different car, the 1994 Ford RV Cutaway, 1994 Ford Econoline, 1994 Ford Cutaway, and 1994 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set transmission in Park or Neutral. Turn A/C and heater off. Connect inductive timing light to engine. With engine off, unplug in-line SPOUT (Yellow/Light Green wire near distributor) connector, or remove shorting bar from the double-wire SPOUT connector. Start and warm engine to normal operating temperature. DO NOT start engine with remote starter switch; use only ignition key.
  2. With engine at idle speed, check/adjust initial timing to 10 degrees BTDC. Turn engine off. Reconnect the single-wire in-line SPOUT connector or reinstall shorting bar on double-wire SPOUT connector. Start engine. Verify timing advances beyond initial setting. Remove test equipment and reconnect all components.
scientia non olet · About LEMON Manuals