Acceleration Circuit Shorted
- Turn ignition off. Disconnect EEC-IV control module from wiring harness. EEC-IV control module is located at right side cowling. Open trunk, and lower ARC module package tray behind left side of back seat.
- Using DVOM, check resistance between pins No. 28 and 60 at ARC module harness connector. If resistance is greater than 1000 ohms, throttle position signal or EEC-IV module is defective. See appropriate TESTS W/CODES article in the ENGINE PERFORMANCE Section. If resistance is less than 10 ohms, repair short to ground in Orange/White wire (circuit No. 836) between ARC module and EEC-IV module.