Door Glass
- Remove door trim panel and watershield. See DOOR TRIM
.
- Lower door glass approximately 75mm (3 inches) from full-up position.
- Loosen nut and washer assemblies retaining the equalizer bracket to door inner panel. See Fig 1
.
- Loosen nut and washer assembly retaining door glass stabilizer.
- With door open, place hands on each side of glass and pull glass fully into door glass run assembly at B-pillar.
- Apply a downward pressure on the equalizer bracket and tighten nut and washer to 9-14 N. m (7-10 Ft. Lbs.).
- Set door glass stabilizer so that it is slightly touching glass and tighten nut and washer assembly to 9-14 N. m (7-10 Ft. Lbs.).
- Cycle door glass to ensure proper operation.
Courtesy of FORD MOTOR CO.