LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Probe GL, Automatic >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System - Variable Assist >> Pinpoint Tests >> Pinpoint Test B3 >> Circuit Continuity Check

Circuit Continuity Check

Leave VAPS control module disconnected. Disconnect ignition coil connector (single wire on non-turbo model or4-wire connector on turbo models). Set VOM on 200-ohm scale. Measure resistance between Yellow/Blue wires at coil connector and VAPS control module connector. If resistance is less than 5 ohms, proceed to PINPOINT TEST B4  . If resistance is NOT as specified, service wire for open.

scientia non olet · About LEMON Manuals