Power Window Motor: Installation

Position the motor and drive to the regulator and install the three screws snug, not tight.
Connect the motor wires at the connector and cycle the glass to ensure gear engagement. After the gears are engaged, tighten the three motor and drive attaching screws to specification. See TORQUE SPECIFICATIONS .

NOTE: Appropriate plug buttons may be installed to cover the exposed hole at the trim panel edge, if necessary.

Install the door trim panel and watershield.
Connect battery ground cable.
Check the drain holes at the bottom of the doors to ensure that each is open to prevent water buildup over the motor.

Position the motor and drive to cable drum housing and motor mounting bracket and install three motor screws. Tighten to specification. See TORQUE SPECIFICATIONS .
Connect power window motor wiring and battery ground cable.
Check window operation, install watershield, door panel and armrest.