LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Bronco 4.9 Y, Standard, M5OD-R2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Drive Axle - Front) >> Removal & Installation >> Axle Housing Assembly >> Installation

Axle Housing Assembly: Installation

WARNING: This page is about a different car, the 1991 Ford Aerostar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install axle mounting bracket to axle housing, if removed. Install mounting bracket bolts using Loctite and tighten to specification. See TORQUE SPECIFICATIONS  table.
    NOTE: If using new axle housing mounting bushings, tighten each lock nut to full torque in one step.
  2. Insert axle housing bushing studs (4) through axle mounting brackets. Install axle housing mounting bushing stud lock nuts using Loctite, and tighten in sequence to specification.
  3. Tightening sequence is as follows: left front, right front, pinion and rear. See TORQUE SPECIFICATIONS  table. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals