Downshift Switch
- Inspect wiring and components for shorts, corrosion, overheating, loose connections, or any other damage. Check 10-amp METER fuse. Disconnect downshift solenoid.
- With key off, voltage measured at Black/Blue wire should be zero volts. With key on and accelerator pedal fully depressed, voltage should be greater than 10 volts. If Black/Blue wire is okay, remove downshift solenoid.
- Apply battery voltage to downshift solenoid connector and ground case. Control rod should move freely when solenoid case is grounded. If control rod does not move freely, replace downshift solenoid.