LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Power Windows) >> Removal & Installation >> Window Motor >> Installation

Window Motor: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1991 Ford RV Cutaway, 1991 Ford Pickup, 1991 Ford F-Super Duty, 1991 Ford Econoline, and 1991 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new motor and drive assembly and engage the motor to regulator. Tighten motor retaining screws to 50-85 INCH lbs. (5.6-9.6 N.m).
  2. Install two pieces of Pressure-Sensitive Waterproof Tape D6AZ-19627-A, or equivalent body tape 1" Square (25.4 mm) over drilled holes.
  3. Connect power window motor wiring. Connect battery ground cable.
  4. Remove glass prop and check window operation.
  5. Ensure door drain holes are open.
  6. Install trim panel. See DOOR TRIM PANEL (BRONCO & F-SERIES)  or DOOR TRIM PANEL (ECONOLINE)  .
scientia non olet · About LEMON Manuals