LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System (Gasoline) >> Air Intake Throttle Body >> Removal & Installation (2.3L)

Removal & Installation (2.3L)

  1. Remove throttle linkage shield. Disconnect throttle linkage, cruise control and kickdown cable. Unbolt accelerator cable and position out of way. Disconnect wire connectors at throttle position sensor and air by-pass valve.
  2. Disconnect air intake hose from throttle body. Disconnect PCV hoses. Disconnect EGR tube by removing flange nut. Remove throttle body nuts/bolts.
  3. Carefully separate throttle body from upper intake manifold. Clean gasket surfaces, but do not allow gasket material to fall into upper intake manifold. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals