LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1990 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock >> Diagnosis >> Trouble Codes >> Code 10 (Low Sensor Resistance)

Code 10 (Low Sensor Resistance)

  1. Turn ignition off. Unplug RABS sensor connector at sensor. Measure resistance between sensor pins. If resistance is 1000 ohms or less, replace sensor. If resistance is more than 1000 ohms, disconnect battery. With RABS sensor connector apart from sensor, unplug control module connector.
  2. Measure resistance between module pin No. 10 and chassis ground. See Figure . If resistance is less than 20,000 ohms, repair short to ground between RABS sensor and control module. If jumper harness between RABS sensor and frame rail is defective, replace ONLY with original equipment High Flex Wire. Splice Connector (E6EB-14488-AA) MUST be used.
  3. If resistance is 20,000 ohms or more, measure resistance between module connector pins No. 3 and 10. If resistance is 20,000 ohms or more, replace control module. If resistance is less than 20,000 ohms, repair short between RABS sensor wires. If jumper harness between RABS sensor and frame rail is defective, replace ONLY with original equipment High Flex Wire. Splice Connector (E6EB-14488-AA) MUST be used.
scientia non olet · About LEMON Manuals