Removal & Installation: Motor: Removal

Disconnect battery negative cable. Remove door trim panel. Disconnect power window motor wire from harness connector. Using a 1/2" diameter drill bit, drill 2 holes in door inner panel at drill dimples, located opposite 2 unexposed motor drive retaining screws.
NOTE: Check before drilling to ensure no wires are in line with holes to be drilled.
Using 2 holes drilled in step 1) and existing access hole, remove 3 motor mount retainer screws. Push motor outward to disengage motor and drive from regulator gear. After motor and drive are disengaged, prop window in full up position. Remove motor and drive.