LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1984 >> Bronco 5.0 F, Automatic >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Wheel Alignment Specifications & Procedures >> Adjustment >> Riding Height >> All Models

All Models

  1. Check riding height as shown in Fig 1 . On F Series, make sure that riding heights are set so that left side riding height is 3/8" higher than the right side riding height.
  2. On F Series 4WD and Bronco models, make sure that riding heights are within 3/16" of each other. If riding heights are not within specifications, correct heights by re-distributing load on vehicles or slightly loading empty vehicles on one side. If riding heights cannot be brought to specifications, verify correct spring installation.
NOTE: For Fig 1 , the axle gap is measured from the rubber spring stopper and the top of the lower control arm.
Fig 1: Riding Height Axle Gap Measurement (Typical) Adjust height before checking caster or camber angles.
G202053
scientia non olet · About LEMON Manuals