LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1982 >> Cab & Chassis Courier >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Columns >> Overhaul >> Standard Column >> Reassembly ("E" Models)

Reassembly ("E" Models)

  1. On 3 speed manual transmission models, place bushing in socket retainer in outer tube. Place bushing on upper hub and wave washer on lower hub of shift socket. Insert lower shift arms and spacer in outer tube.
  2. Insert shift tube assembly from top of column on 3 speed models, or from bottom on automatic transmission models. Install shift socket onto shift tube in outer tube, or flange extension onto outer tube and tighten.
  3. Install shift tube retaining screw in bottom of shift socket on automatic models. Place turn signal-hazard warning switch wiring harness through flange. Press lamp and wire into flange on automatics.
  4. Feed turn signal harness through shift socket by pinching the flange casting retaining nuts toward each other. Install upper flange. Install ignition switch actuation rod and ignition switch, and hand tighten nuts.
  5. With ignition switch mounting nuts loose, clip the switch through the opening in the side of the switch casting. Center the switch on the actuation rod. Tighten retaining nuts and remove clip.
  6. Install steering shaft from bottom of column. Install lower bearing retainer. Install upper shaft bearing and tire. Install snap ring on shaft above upper bearing. Install turn signal-hazard warning switch.
  7. Install shift indicator on automatic models. Install shift lever and turn signal lever. Install steering wheel and column in vehicle.
scientia non olet · About LEMON Manuals