Single Switch
- With the switch in the neutral position, use an ohmmeter to test switch. Continuity should exist between terminals 1, 2, 3, and 5. Continuity should also exist between 4 and 6. See Figure.
- With switch pushed downward, continuity should exist between 2, 4 and 5. Continuity should also exist between 1 and 3. Terminal 6 should be disconnected from all other terminals.
- With switch pushed upward, there should be continuity between terminals 2, 3, and 5; also 4 and 6. Terminal 1 should be disconnected from all other terminals. If switch does not operate as indicated in any test, replace switch.