Ignition Switch Lock Drive Gear
Remove lock cylinder, then remove cylinder spring clips. Using a screwdriver inserted in drive gear recess, turn lock drive gear three notches counterclockwise. Remove snap ring, washer and lock gear from housing. Note relationship of lock drive gear to position of rack teeth. To install drive gear, reverse removal procedure and note following. Lock drive gear position is correct if last tooth on gear is meshed with last tooth on rack.
TIGHTENING SPECIFICATIONS
| Application | Ft. Lbs. |
|---|---|
| Flexible Coupling Nuts | 20-37 |
| Universal Joint Lock Nuts | 25-35 |
| Vibration Bracket | 20-37 |
| Lower Collar-to-Brake Support | 20-37 |
| Steering Wheel Nut | 30-40 |
| Application | INCH Lbs. |
|---|---|
| Turn Signal Switch Screws | 20-30 |
| Flange-to-Outer Tube Allen Screws | 60-75 |
| Shift Tube-to-Socket Casting | 35-50 |
| Lower Bearing Casting-to-Tube (Mini Only) | 20-25 |
| Lower Bearing Retainer-to-Flange Casting | 12-20 |