Valve Clearance: Notes
Adjust valves with engine cold. To adjust, turn adjusting screw until correct clearance is obtained.
NOTE:
Do not use go/no-go type feeler gauge. Check clearance fore and aft parallel to crankshaft centerline. Any other method will result in an incorrect reading.
Adjust valves in the following sequence.
| Valves Open | Adjust Valves |
|---|---|
| No. 1 & 6 | No. 3 & 8 |
| No. 2 & 4 | No. 5 & 7 |
| No. 3 & 8 | No. 1 & 6 |
| No. 5 & 7 | No. 2 & 4 |
Valve Clearance
| Application | Clearance | ||
|---|---|---|---|
| Intake | (1).010" (.25 mm) | ||
| Exhaust | (1).021" (.53 mm) | ||
|
|||