LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2020 >> 500L Pop >> Repair and Diagnosis >> Quick Lookups >> Common Specs & Procedures >> Common Specs & Procedures

Common Specs & Procedures

FIAT 500L COMMON SPECS & PROCEDURES

System Specification/Procedure
Air Conditioning
Service A/C SYSTEM
Torque FASTENER TORQUE
Axle Nut/Hub Nut
Front 52 ft. lbs. + 62° (70 N.m + 62°)
Rear 207 ft. lbs. (280 N.m) Do not reuse fastener. If removed for service, a new one must be installed and tightened to specifications. 
Battery SPECIFICATIONS
Brakes
Bleeding Sequence Base: STANDARD PROCEDURE - BASE BRAKE BLEEDING , Antilock: STANDARD PROCEDURE - ANTILOCK BRAKE SYSTEM BLEEDING .
Disc Brakes
Service Specifications SPECIFICATIONS .
Torque TORQUE
Drum Brakes
Service Specifications N/A
Torque N/A
Charging
Generator GENERATOR
Torque TORQUE
Drive Belts
Adjustment Serpentine belt used, not adjustable.
Drive Belt Routing Refer to appropriate "Belt Routing" figure under INSTALLATION
Engine Cooling
General Service Specifications COOLANT
Radiator Cap Pressure 21 psi (145 kPa)
Thermostat R & I THERMOSTAT
Water Pump R & I PUMP, WATER
Engine Mechanical
1.4L
Compression CYLINDER COMPRESSION TEST
Oil Pressure Pressure @ Curb Idle Speed: > 10 psi (> 0.7 bar), Pressure @ 4000 RPM: > 58 psi (> 4.0 bar): At Normal Operating Temperatures
Overhaul SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Fluid Specifications See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate/Drive Plate Torque
1.4L
Flexplate 15 ft. lbs. (20 N.m) + 50° degree turn
Fuel System
Pressure Specification 50.8 psi (350 kPa) +/- 43.6 psi (25 kPa)
Fuel Pressure Test Procedure CHECKING THE FUEL DELIVERY SYSTEM
Fuel Filter Location Located on fuel pump module
Fuel Filter R & I MODULE, FUEL PUMP
Ignition
Firing Order & Cylinder Identification FIRING ORDER & CYLINDER IDENTIFICATION
Ignition Wires (Resistance) Coil On Plug
Ignition Wires (Routing) Coil On Plug
Spark Plug
1.4L
Type 68070507AB
Gap 0.025 in. (0.65 mm)
Torque 12 ft. lbs. (16 N.m)
Starting
Starter Information not available from manufacturer.
Torque Torque specifications are in text under INSTALLATION
Wheel Alignment
Adjustment Specifications TECHNICAL SPECIFICATIONS
Torque
Front SPECIFICATIONS
Rear TORQUE SPECIFICATIONS
Wheel & Tire
Wheel Lug Nut Torque Aluminum Wheels: 89 ft. lbs. (120 N.m), Steel Wheels: 63 ft. lbs. (86 N.m)