Module, Heated Seat (HSM): Installation
WARNING: This page is about a different car, the 2020 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Properly align the Heated Seat Module (HSM) retaining tabs to the driver seat bottom pan, prior to engagement. Failure to follow these instructions may result in damage to the HSM.
- Position the Heated Seat Module (HSM) (2) to the driver seat and engage the outboard HSM retaining tabs (3) to the seat bottom pan (5). Make sure the retaining tabs are correctly engaged to the seat bottom pan.
- Engage the inboard HSM retaining tab (1). Make sure the retaining tab is fully engaged to the seat bottom pan.
- Connect the electrical connectors (4) to the HSM.
- Install the seat. Refer to SEAT, INSTALLATION .
- Reconnect the negative battery cable.
Once the key is cycled to the ON position, the HSM will be configured to the vehicle. Check for DTCs and operation. If DTCs are present. Refer to DIAGNOSTIC CODE INDEX .