LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2020 >> 124 Spider Lusso, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Steering System) >> Pump >> Removal >> 3.6L Engine

3.6L Engine

WARNING: This page is about a different car, the 2020 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
GC0147042Courtesy of CHRYSLER GROUP, LLC
  1. Remove negative (-) battery cable from battery and isolate cable.
  2. Remove cap from power steering fluid reservoir.
  3. Using a siphon pump, remove as much power steering fluid as possible from power steering fluid reservoir.
  4. Remove accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
  5. Raise and support vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  6. Remove exhaust pipe (Refer to 11 - Exhaust System/PIPE, Exhaust Crossunder/Removal).
  7. Remove 3 heat shield mounting bolts (2). Remove heat shield (1) from vehicle.
    GC0147044Courtesy of CHRYSLER GROUP, LLC
  8. Remove supply hose clamp (1) and remove supply hose from power steering pump fitting.
    GC0147043Courtesy of CHRYSLER GROUP, LLC
  9. Remove power steering pump pressure hose fitting (2).
  10. Remove three pump mounting bolts through pump pulley (not shown in figure).
  11. Remove pump (1) (with pulley) from below.
  12. If pulley needs removal. Refer to PULLEY, POWER STEERING PUMP, REMOVAL .
scientia non olet · About LEMON Manuals