3.6L Engine

WARNING: This page is about a different car, the 2020 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Before installing power steering pressure hose on power steering pump, replace O-ring on end of power steering pressure hose. Lubricate O-ring using clean power steering fluid.

Install power steering pump (1) onto its mounting bracket.
Install three power steering pump mounting bolts through pulley (not shown in figure). Tighten the pump mounting bolts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
Install power steering pump pressure fitting (2) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC
Slide fluid supply hose onto pump (3) fitting and install clamp (1) securing it in place.

Courtesy of CHRYSLER GROUP, LLC
Install heat shield (1) and secure with three heat shield mounting bolts (2). Tighten the bolts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
Install exhaust pipe (Refer to 11 - Exhaust System/PIPE, Exhaust Crossunder/Installation).
.
Lower vehicle.
Install accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
Connect negative (-) battery cable on negative battery post.
Fill and bleed power steering system. Refer to STANDARD PROCEDURE .
Inspect for leaks.