2.0L/2.4L Engine
WARNING: This page is about a different car, the 2020 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
- Using a lint free towel, wipe clean the open power steering pressure hose end and the power steering pump port. Replace any used O-rings with new. Lubricate the O-ring with clean power steering fluid.
- Place the pump in mounting position. Install the three bolts (1) through the pulley (3) openings. Tighten the mounting bolts (1) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install the drive belt (2) Refer to BELT, SERPENTINE, INSTALLATION
.
- Install the supply hose (1) at the pump (3).
- Clamp the hose clamp (2) securing the supply hose (1) to the pump.
- Install the pressure hose (3) at the pump pressure port (5). Tighten the tube nut to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install the pressure hose routing bracket bolt (2) to the engine mount (8). Tighten the bolt to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Fill and bleed the power steering system. Refer to STANDARD PROCEDURE .
- Check for leaks.
- Install the engine appearance cover.