Module, Security Gateway (SGW): Removal

WARNING: This page is about a different car, the 2020 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, use a diagnostic scan tool to perform the Flash Programming Procedure (if available).

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the driver side kneeblocker. Refer to KNEEBLOCKER, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC

NOTE:
The Security Gateway Module (SGW) is mounted to the IP on a bracket behind kneeblocker.
Remove the fasteners (1) and disconnect the SGW wire harness connectors (2).
Remove the SGW module from the vehicle.