Module, Security Gateway (SGW): Installation

WARNING: This page is about a different car, the 2020 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If a NEW Security Gateway (SGW) module is being installed, use the diagnostic scan tool to flash the module. Failure to flash the module will leave the SGW module in a locked mode preventing SGW module operation.

Position the SGW module to the mounting studs.

Courtesy of CHRYSLER GROUP, LLC
Install the SGW module fasteners (1) and tighten securely.
Connect the SGW module wire harness connectors (2).
Install the driver side kneeblocker. Refer to KNEEBLOCKER, INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
If a NEW SGW module is installed, use the diagnostic scan tool to flash the SGW module.