LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2019 >> 500L Pop >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Electronic Control Modules (Service Information)) >> Module, Radio Frequency (RF Hub) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2019 Fiat 500X. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that the Remote Frequency Hub Module (RFHM) is not damaged.
  2. Place the RFHM to the vehicle and tighten the nuts.
  3. Connect the electrical connectors to the RFHM.
  4. Install the rear quarter trim panel. Refer to PANEL, QUARTER TRIM, INSTALLATION .
  5. Connect the diagnostic scan tool and perform the learn procedure.
    NOTE:

    If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

scientia non olet · About LEMON Manuals