LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2019 >> 500L Lounge >> Repair and Diagnosis >> General Information >> Specifications Index >> Common Specs & Procedures >> Common Specs & Procedures

Common Specs & Procedures

FIAT 500L COMMON SPECS & PROCEDURES

System Specification/Procedure
Air Conditioning
Service A/C SYSTEM
Torque TORQUE SPECIFICATIONS
Axle Nut/Hub Nut
Front 52 ft. lbs. + 62° (70 N.m + 62°)
Rear 207 ft. lbs. (280 N.m) Do not reuse fastener. If removed for service, a new one must be installed and tightened to specifications. 
Battery SPECIFICATIONS
Brakes
Bleeding Sequence Refer to BASE BRAKE BLEEDING , or ANTILOCK BRAKE SYSTEM BLEEDING .
Disc Brakes
Service Specifications SPECIFICATIONS .
Torque TORQUE SPECIFICATIONS
Drum Brakes
Service Specifications N/A
Torque N/A
Charging
Generator GENERATOR
Torque TORQUE SPECIFICATIONS
Drive Belts
Adjustment Serpentine belt used, not adjustable.
Drive Belt Routing Refer to appropriate "Belt Routing" figure under INSTALLATION
Engine Cooling
General Service Specifications GENERAL SPECIFICATIONS
Radiator Cap Pressure 21 psi (145 kPa)
Thermostat R & I THERMOSTAT
Water Pump R & I PUMP, WATER
Engine Mechanical
1.4L
Compression Compression should not be less than 689 kPa (100 psi) and not vary more than 25 percent from cylinder to cylinder.
Oil Pressure Pressure @ Curb Idle Speed: > 10 psi (> 0.7 bar), Pressure @ 4000 RPM: > 58 psi (> 4.0 bar): At Normal Operating Temperatures
Overhaul SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Fluid Specifications See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate/Drive Plate Torque
1.4L
Flexplate 15 ft. lbs. (20 N.m) + 50° degree turn
Fuel System
Pressure Specification 58 psi (400 kPa) +/- 4 psi (25 kPa)
Fuel Pressure Test Procedure Refer to CHECKING THE FUEL DELIVERY SYSTEM
Fuel Filter Location Information not available from manufacturer.
Fuel Filter R & I Information not available from manufacturer.
Ignition
Firing Order & Cylinder Identification FIRING ORDER & CYLINDER IDENTIFICATION
Ignition Wires (Resistance) Coil On Plug
Ignition Wires (Routing) Coil On Plug
Spark Plug
1.4L
Type 68070507AB
Gap 0.025 in. (0.65 mm)
Torque 12 ft. lbs. (16 N.m)
Starting
Starter Information not available from manufacturer.
Torque Torque specifications are in text under INSTALLATION
Wheel Alignment
Adjustment Specifications TECHNICAL SPECIFICATIONS
Torque
Front TORQUE SPECIFICATIONS
Rear TORQUE SPECIFICATIONS
Wheel & Tire
Wheel Lug Nut Torque Aluminum Wheels: 89 ft. lbs. (120 N.m), Steel Wheels: 63 ft. lbs. (85 N.m)